top of page
Bucket.png

Use Cases

• Interior (if applying material outdoors, use KRETUS® Poly Patch EZ)

• Horizontal Concrete Surfaces

• Industrial/Heavy-Duty Traffic

• Repair Cracks and Moving and Non-Moving Joints

• Fill New Construction Saw-Cut Joints and Control Joints

• Protect Joint Edges from Spalling

• Industrial, Healthcare, Commercial, Government, Institutional, and Residential

Poly Patch

  • • Interior (if applying material outdoors, use KRETUS® Poly Patch EZ)

    • Horizontal Concrete Surfaces

    • Industrial/Heavy-Duty Traffic

    • Repair Cracks and Moving and Non-Moving Joints

    • Fill New Construction Saw-Cut Joints and Control Joints

    • Protect Joint Edges from Spalling

    • Industrial, Healthcare, Commercial, Government, Institutional, and Residential

  • • Meets USDA, FDA, EPA, and SCAQMD Standards

    • Eligible for LEED Points: Made in California from 

    Partially Recycled Materials

    • Adhesion to Concrete, Wood, Metal, Non-glazed Tiles

    • Antibacterial

    • High Impact Resistance

    • High Traffic and Hot Tire Resistance

    • Low Maintenance

    • Low Odor

    • Rapid Set (FC Only): Cut in 8 Minutes, Full Cure in 30 Minutes

    • Suitable for Outdoor Applications (EZ Only)

    • Waterproofing

  • • Outdoor application: If applying material outdoors, use KRETUS® Poly Patch EZ. 

    • Use in areas where operation temperatures remain between 20°F (-7°C) and 120°F (49°C). For lower temperatures, 

    contact your KRETUS® Technical Representative.

    • The thicker the application, the faster it will cure. Do NOT apply any single layer thicker than 2 inches.

    • Do NOT install under VCT or any nonbreathable flooring systems. 

    • Mixing: Use a static mixer with dual-cartridge caulking gun or dual-feed power pump to combine and dispense material. 

    Do NOT combine Part A with Part B by hand. Short gel time (1-2 minutes) makes manual dispensing impractical. 

    • Application temperatures: Material cures faster as temperature increases. Material cures slower as temperature 

    decreases. All times were measured and recorded under controlled lab conditions at 70°F. Working and cure times vary 

    based on ambient conditions. Apply material when temperature is decreasing—adhere to the KRETUS® Dew Point 

    Calculation Chart available at kretus.com/project-planning. If application temperatures are outside of those 

    recommended, contact your KRETUS® Technical Representative. 

    • DO NOT apply under direct sunlight. DO NOT install under inclement weather conditions.

    • Coverage rates are for estimating purposes only. Factors such as waste, unusual/abnormal substrate conditions, and 

    other unforeseen jobsite conditions may affect actual product yields and are the responsibility of the installer.

    • Complete samples and onsite mockups to ensure desired results are achieved. 

    • Recommended for Applicators level 4 and up. (See kretus.com/applicator-skill-level.)


Repair and fill random cracks and protect joints from spalling with rapid-setting flexible (FC Only), solvent-free KRETUS® POLY PATCH. This two-part, 100%-solids polyurea liquid system moves with adjacent concrete and withstands heavy industrial traffic.

bottom of page