top of page
Bucket.png

Use Cases

• UV-stable decorative systems

• protective top coat over functional and decorative finishes

• industrial, healthcare, commercial, government, institution, and residential areas

Polyurethane

  • • UV-stable decorative systems

    • protective top coat over functional and decorative finishes

    • industrial, healthcare, commercial, government, institution, and residential areas

  • • compliance: meets USDA, FDA, EPA, SCAQMD, and VOC standards

    • antimicrobial: protect against bacterial and fungal growth

    • chemical & stain resistant: withstands exposure to harsh chemicals, food and drink, and cleaners

    (For test results, see KRETUS® Chemical Resistance Chart at kretus.com/project-planning.)

    • ez clean: requires little effort to maintain (For detailed maintenance, see KRETUS® Maintenance and 

    Cleaning Guide at kretus.com/project-planning.)

    • freeze cure: can be applied at or above -20°F

    • green building: eligible for LEED points, locally produced from partially recycled materials

    • high-traffic tolerant: stands up to vehicle traffic and continuous pedestrian traffic

    • hot-tire resistant: curbs delamination caused by hot tires

    • scratch resistant: conceals minor scratches

    • UV resistant: protects against deterioration and discoloration from intense lighting and sun exposure

    • waterproofing: protects surfaces and underlying areas from water intrusion

  • • Do not let material puddle on floor—this will cause white spots to appear when Polyurethane cures. 

    • Adding Poly Colorant may reduce working time by 5 minutes. If combining with FC hardener, mix in small 

    batches or increase number of installers.

    • A single coat of Polyurethane HP should be 5 mils thick or less (5 mil = 320 sf/gal). For Polyurethane HS, 

    single coats may be applied up to 20 mils thick (20 mils = 120 sf/gal). If installation requires thicker single 

    coat, use KRETUS® Urethane Polymer Concrete UV or Top Shelf® Epoxy. 

    • If installation requires application greater than 5 mils, use KRETUS® Polyurethane HS or Polyaspartic. 

    • Do not install Polyurethane HP directly over moisture-sensitive concrete, broadcasted vinyl chip, 30-grit 

    or larger quartz, or 80-mesh or larger aluminum oxide.

KRETUS® Polyurethane HP and HS are high-solids, two-component systems perfect for high-traffic areas such as forklift loading zones, valet drive aprons, and commercial walkways. Choose from various Polyurethane HP (High Performance) products to change appearance from satin to gloss and increase UV protection when needed. Polyurethane HS (High Shine) is designed for high-build applications where a top-performing sealer or top coat is required

bottom of page